Mercurial > repos > blastem
graph
-
Add debugger command for saving Z80 RAM to a fileTue, 11 Jun 2013 23:10:33 -0700, by Mike Pavone
-
Bail out on attempt to run code from bank area until it is properly supportedTue, 11 Jun 2013 23:09:57 -0700, by Mike Pavone
-
Fix address adjustement in z80_retrans_stubSun, 09 Jun 2013 02:38:56 -0700, by Mike Pavone
-
Z80 debugger improvementsSun, 09 Jun 2013 02:03:26 -0700, by Mike Pavone
-
Check memory results in ztestgenSat, 08 Jun 2013 12:59:23 -0700, by Mike Pavone
-
Use a call instruction to figure out the original native address when retranslating so that it does not get lost when the byte transforms from a instruction word to extension wordSat, 08 Jun 2013 11:31:52 -0700, by Mike Pavone
-
Removed out of date TODOThu, 06 Jun 2013 08:45:54 -0700, by Mike Pavone
-
Fix LDD and LDDRThu, 06 Jun 2013 08:19:25 -0700, by Mike Pavone
-
Fix dec and inc when the operand is in memoryWed, 05 Jun 2013 22:55:23 -0700, by Mike Pavone
-
Fix channel mapping in key on/off registerWed, 05 Jun 2013 19:26:02 -0700, by Mike Pavone
-
Fix LDIWed, 05 Jun 2013 18:47:39 -0700, by Mike Pavone
-
Fix set/res when the operand is in memoryTue, 04 Jun 2013 22:30:49 -0700, by Mike Pavone
-
Initial implementation of channel 3 special modeTue, 04 Jun 2013 21:23:12 -0700, by Mike Pavone
-
Fix operator precedence bug with sustain levelTue, 04 Jun 2013 09:16:41 -0700, by Mike Pavone
-
Fix modulation shift valueMon, 03 Jun 2013 23:44:11 -0700, by Mike Pavone
-
Make shift value of operator output to modulation input a defineSun, 02 Jun 2013 22:37:48 -0700, by Mike Pavone
-
Adjust shift for feedbackSun, 02 Jun 2013 22:33:27 -0700, by Mike Pavone
-
Initial stab at feedbackSun, 02 Jun 2013 22:30:41 -0700, by Mike Pavone
-
Fix key scalingSun, 02 Jun 2013 21:52:42 -0700, by Mike Pavone
-
Clear IFF1 and IFF2 when an interrupt is taken on the Z80Sun, 02 Jun 2013 21:38:18 -0700, by Mike Pavone
-
Fix YM2612 busy flagSun, 02 Jun 2013 21:12:43 -0700, by Mike Pavone
-
Fix cycle count for inc and decSun, 02 Jun 2013 21:12:26 -0700, by Mike Pavone
-
Bunch of Z80 debugger improvementsSun, 02 Jun 2013 20:14:27 -0700, by Mike Pavone
-
Use signed ints for things that represent signed values in YM2612 coreSun, 02 Jun 2013 13:42:33 -0700, by Mike Pavone
-
Fix register to operator mapping. Fix rate table generation. Add TL to envelope value rather than using it as a limit for the attack phase.Sun, 02 Jun 2013 00:00:22 -0700, by Mike Pavone
-
Fix left/right enable default valueFri, 31 May 2013 21:30:11 -0700, by Mike Pavone
-
Make the n command in the Z80 debugger actually run the next instruction without needing a c commandFri, 31 May 2013 20:47:34 -0700, by Mike Pavone